Gerber EDGE Owner's Manual page 21

To load the material
1. The display shows the material loading prompt:
Vinyl: WHITE
2. Push in the cover latch and raise the cover.
3. Push the bail arm latch toward the rear of the
the raised position.
4. Clean the bail arm squeegees and platen using a clean, lint-free pad
moistened with isopropyl alcohol. Allow to air dry before loading material.
5. Press the HOME key once to rotate the drive sprockets to the home position.
(The three closely spaced teeth face up.)
6. Position the tensioner assembly next to the right (on/off switch) side of the
and slide the roll of white vinyl material onto the roll holder. Pull the
EDGE
end of the material away from the
arm roller toward the side of the
7. Seat the three-hole pattern in the vinyl over the three closely spaced teeth in
each sprocket. Lower the bail arm and push the bail arm latch toward the
rear of the so that the latch locks the bail arm down.
EDGE
8. Slew the vinyl back and forth so that the squeegees clean the area to be
printed. Leave a leader of at least 2" (5 cm) beyond the left squeegee.
To load the color cartridge
1. Press ONLINE on the keypad. The display shows:
Foil: RUBY RED
2. If necessary, remove an installed color cartridge by pushing down and
rotating the three cartridge pins under the cartridge plate. Rotate the color
cartridge to the left from behind the curve of the support bracket and remove
the color cartridge.
3. Clean the printhead with the pen printhead cleaner or use a pad moistened
with 98% or higher isopropyl alcohol. Do not soak the pad with alcohol or
you may damage the printhead. Gently rub the entire length and width of the
printhead and the surrounding metal. Dry with a clean, lint-free cloth.
4. Clean both sides of the foil squeegee using a pad moistened with isopropyl
alcohol. Allow to air dry.
5. Remove and discard the foam core locks from the color cartridge.
Getting Started
and lift the bail arm to
EDGE
, then under and over the tension
EDGE
.
EDGE
15