Gerber EDGE Owner's Manual page 46

40 GERBER EDGE Owner's Guide
Matching the checksum of the EDGE to the Gerber software
If the Gerber software release
installed on your computer is:
GA 4.3, GA 6.0 or higher, or
If the
EDGE
and you will get a
EDGE
time you send a job.
Matching the checksum of the EDGE to the Spool File
If the spool file you are printing
was saved in Gerber software
release:
GA 4.3, GA 6.0 or higher, or
If the checksum settings of the saved spool file and the
you will get a
one of these files for printing. You have two choices:
Rerender GA 4.1 spool files in GA 4.3 so that they are now GA 4.3 files.
Refer to the Gerber software reference manual for information on creating
spool files.
Set the
Note: This situation applies only to spool files. Files originally created in GA
4.1 will print as GA 4.3 files if they were not saved as spool files.
OMEGA
4.1
checksum is not set correctly, you will not be able to print on the
DATA ERROR
OMEGA
4.1
DATA ERROR message on the keypad display every time you send
checksum to ON when printing GA 4.1 spool files.
EDGE
Then the EDGE checksum must
be set to:
OFF (This is the factory setting. You
do not have to change the setting.)
ON (You must change the setting.)
message on the keypad display every
Then the EDGE checksum must
be set to:
OFF (This is the factory setting. You
do not have to change the setting.)
ON (You must change the setting.)
are not the same,
EDGE