Gerber EDGE Owner's Manual page 44

38 GERBER EDGE Owner's Guide
Online Paused mode
Pressing the ONLINE (ON) key or the RESET (RS) key while printing puts the
in the Online Paused mode. The job stops printing and you can:
EDGE
look at the job while it is still in the
slew the foil (FS)
To restart printing at the same location where printing was interrupted, press the
ONLINE (ON) key. To abort the job, press the RESET (RS) key. The display
will ask you to
and the printer returns to the Offline mode. If you press ONLINE (ON), the job
resumes.
Note: To ensure correct registration when printing is resumed, the EDGE is set
to overlap the foil (by 15 pixels) at the position where it was interrupted. You
may reset this amount to any value between 5 and 25 pixels by following the
instructions in "Changing the EDGE overlap settings" on page 42.
Online Error mode
If an error occurs while printing, printing stops, an error message displays in the
message display area, and the
possible messages and your response to each is in the "Troubleshooting" section
of this manual (page 43).
After taking corrective action, press the ONLINE (ON) key to restart printing. If
the error is non-recoverable, you must press the RESET (RS) key. The
returns to the Offline mode and you must resend the job from the Plot program.
Note: If the display message is
required. A time delay allows the printhead to cool down. When the printhead is
sufficiently cool, the
(ON) key to restart printing.
Before pressing the ONLINE key to restart printing, you can:
look at the job while it is still in the
slew the foil (FS)
EDGE
CONFIRM RESET
. If you press RESET (RS) again, the job aborts
enters the Online Error mode. A list of
EDGE
Thermistor Error
Paused
message displays on the keypad. Press the ONLINE
EDGE
and before printing is complete
EDGE
, no immediate action is
and before printing is complete