Gerber EDGE Owner's Manual page 11

To add the EDGE for use by the GA Plot program
Use the Setup program to add the
GSP
®
ADVANTAGE Plot program.
1. Open the Setup program.
GSP
2. Click on Setup in the menu bar.
3. Click on Vinyl Printer. The Add or
Delete Vinyl Printer(s) dialog box
appears.
4. In the Vinyl Printers list box, click
on .
GERBER EDGE
5. In the Ports list box, click on
6. Click on Add. The
EDGE
7. In the Installed Vinyl Printers list box, click on
click on Preference. The Set Preference dialog box opens.
8. Click on OK. The
EDGE
9. Click on Continue. The
To add a plotter for use by the GA Plot program
1. Click on Setup in the
menu bar.
2. Click on Plotter. The Add or Delete
Plotter/Router(s) dialog box
appears.
3. In the Devices list box, click on the
name of the plotter you will use to
cut the printed job.
4. In the Ports list box, click on
port the plotter is connected to.
5. Click on Add. The plotter is added to the Ready for Plotting list box.
6. Click on Continue. The plotter is added to the system.
7. Exit the Setup program.
GSP
Note: If the Plot Spooler is an icon on the Windows desktop, close out the icon
so that when it is reopened, the new vinyl printer and plotter will be available.
Unpacking and Setting Up
and plotter to the GRAPHIX
EDGE
.
LPT2
is added to the Installed Vinyl Printers list box.
is shown as the default vinyl printer.
is added to the system as the default printer.
EDGE
program
GSP
COM1, COM2, COM3
, and then
GERBER EDGE
, or to choose the
COM4
5