Gerber EDGE Owner's Manual page 47

Changing the EDGE checksum setting for GA 4.1
Changing the checksum setting consists of opening the Setup menu,
EDGE
setting the checksum to OFF or ON, and turning the
complete the checksum change. The checksum is toggled OFF or ON by
pressing either Vinyl Slew key.
To change the EDGE checksum setting
1. Plug in and turn on the
2. The display reads
EDGE
3. Repeatedly press the Setup key until the display reads
ON OFF
by or .
Note: There are additional selections in the Setup menu that are used for
Gerber diagnostic purposes only. If you go beyond the menu selection you want,
repeatedly press the SETUP key until that selection appears again in the
display. Do not change any settings except for checksum, test pattern, or
overlap without first consulting the Gerber Field Service Department.
4. Press either VINYL SLEW key so that the display reads
CHECKSUM OFF
.
5. Press the RESET key. The display reads
6. Turn the off, then on. The
EDGE
7. Press the ONLINE key. The display reads
for printing.
Mechanical Description
EDGE
first, then the computer.
EDGE
OFFLINE .
OFFLINE
display reads
EDGE
ONLINE
41
off and on to
CHECKSUM followed
CHECKSUM ON or
.
OFFLINE
.
and the is ready
EDGE