Gerber EDGE Owner's Manual page 18

12 GERBER EDGE Owner's Guide
3. After the
press RESET on the keypad. The display shows:
4. Slew the material out of the side of the machine toward the roll. Wind the
job on the roll. Take the roll to the plotter.
To cut the printed job on a 15" sprocketed plotter
1. Remove the tool from the plotter tool carriage.
2. Open the bail arm by lifting it up from the drum.
3. Use the keypad slew keys to slew the plotter drive sprockets so that the three
closely spaced teeth are facing up.
4. Seat the three-hole pattern in the vinyl over the three closely spaced teeth in
each sprocket and close the bail arm.
5. Slew the tool carriage and vinyl so that the registration mark is visible
through the barrel of the tool carriage.
6. Activate slow slew by pressing the SLOW key.
Note: The plotter beeps once when you enter the Slow Slew mode and beeps
twice when you exit the Slow Slew mode.
7. Insert the eyepiece into the tool carriage as shown. Align the groove in the
eyepiece with the key in the tool carriage so that the eyepiece seats all the
way down (touching the vinyl) in the carriage.
is warmed up, printing starts. When printing is complete,
EDGE
OFFLINE
The eyepiece installed in the tool carriage.