Gerber EDGE Owner's Manual page 23

5. Insert the color cartridge toward the rear of the cover until it touches, then
rides up on, the ramp.
6. Rotate the cartridge to the right until it covers the cartridge pin plate and the
left side of the cartridge is behind the curve of the support bracket.
7. Release the three cartridge pins under the cartridge pin plate so that they
secure the color cartridge in the head support.
8. Press the FOIL SLEW key until the cartridge pins snap into place and the
foil moves.
9. Close the cover and press ONLINE on the keypad.
10. When the printing of the second color is complete, press RESET on the
keypad. The display shows:
OFFLINE
11. Slew the material out of the side of the machine toward the roll. Wind the
job on the roll. Take the roll to the plotter.
To cut the printed job on the 15" sprocketed plotter
1. Remove the tool from the plotter tool carriage.
2. Open the bail arm by lifting it up from the drum.
3. Use the keypad slew keys to slew the plotter drive sprockets so that the three
closely spaced teeth are facing up.
4. Seat the three-hole pattern in the vinyl over the three closely spaced teeth in
each sprocket and close the bail arm.
5. Slew the tool carriage and vinyl so that the registration mark is visible
through the barrel of the tool carriage.
6. Activate slow slew by pressing the SLOW key.
Note: The plotter beeps once when you enter the Slow Slew mode and beeps
twice when you exit the Slow Slew mode.
7. Insert the eyepiece into the tool carriage. Align the groove in the eyepiece
with the key in the tool carriage so that the eyepiece seats all the way down
(touching the vinyl) in the carriage.
8. Sight through the eyepiece and slow slew the material so that the registration
mark is exactly centered in the eyepiece. You can slow slew one step at a
time by tapping the SLEW key or continuous slow slew by pressing the
SLEW key.
Getting Started 17