Gerber EDGE Owner's Manual page 19

8. Sight through the eyepiece and slow slew the material
so that the registration mark is exactly centered in the
eyepiece as shown. You can slow slew one step at a
time by tapping the SLEW key or continuously slow
slew by pressing the SLEW key.
9. Remove the eyepiece from the tool carriage.
10. Put the knife in the tool carriage.
11. Press F8 on the keyboard to cut the job.
12. Press the plotter RUN SINGLE key when the plotter indicator light blinks.
13. When the job is cut, slew the vinyl out of the machine and weed the job.
Getting Started 13