Gerber EDGE Owner's Manual page 22

16 GERBER EDGE Owner's Guide
6. Hold the color cartridge vertically with the label facing toward the inside of
the cover. Orient the cartridge so that the glossy side of the foil faces toward
the right.
7. Insert the color cartridge toward the rear of the cover until it touches, then
rides up on, the ramp.
8. Rotate the cartridge to the right until it covers the cartridge pin plate and the
left side of the cartridge is behind the curve of the support bracket.
9. Release the three cartridge pins under the cartridge pin plate so that they
secure the color cartridge in the head support.
10. Press the FOIL SLEW key until the color cartridge snaps into place and the
foil moves.
11. Close the cover.
To print the job
Note: There may be a pause after you press ONLINE before the printing starts.
1. Press ONLINE on the keypad.
2. The
reads:
3. After the
color, it rewinds the vinyl and the display shows:
To change the color cartridge
1. Raise the cover.
2. Remove the ruby red color cartridge by pushing down and rotating the three
cartridge pins under the cartridge plate. Rotate the color cartridge to the left
from behind the curve of the support bracket and remove the color cartridge.
3. Gently wipe the vinyl, vinyl squeegees, foil squeegee, and printhead with a
clean, dry, lint-free cloth.
4. Load the black color cartridge by holding it vertically with the label facing
toward the inside of the cover. Orient the cartridge so that the glossy side of
the foil faces toward the right.
may go through a brief warm-up cycle. If so, the
EDGE
WARMING UP
is warmed up, printing starts. After the
EDGE
Foil: BLACK
display
EDGE
prints the first
EDGE