Gerber EDGE Owner's Manual page 12

6 GERBER EDGE Owner's Guide
To add the EDGE for use by OMEGA's GSPPlot program
1. Right-click the GSPTray icon to open
the Gerber Tray menu.
2 Click Install Vinyl Printer to open the
Local tab of the Add or Delete Gerber
Vinyl Printer(s) dialog box.
3 Click the appropriate printer from the
Available Vinyl Printers on local
system list.
4 Choose either LPT2 or LPT3 from the Local Port group box.
5 Click Add to open the Add – Name Device dialog box.
6 Either accept the name of the printer in the Device Name box or enter
another.
7 Click OK. The name of the newly installed printer appears in the Installed
Vinyl Printers section of the Add or Delete Vinyl Printer(s) dialog box.
8 Click Close.
To add a plotter for use by OMEGA's GSPPlot program
1. Right-click the GSPTray icon to open
the Gerber Tray menu.
2. Click Install Plotter/Router to open the
Local tab of the Add or Delete
Plotter/Router(s) dialog box.
3. Highlight the appropriate plotter or
router from the Available
Plotter/Router(s) on local system list.
4. Choose COM2, COM3, or COM4 from the Local Port group box.
5. Click Add to open the Add – Name Device dialog box.
6. Either accept the name of the plotter or router in the Device Name box or
enter another.
7. Click OK. The name of the newly installed plotter or router appears in the
Installed Plotter/Router(s) section of the Add or Delete Plotter/Router(s)
dialog box.
8. Click Close.