Gerber EDGE Owner's Manual page 16

10 GERBER EDGE Owner's Guide
5. Position the tensioner assembly next to the right (on/off switch) side of the
EDGE
6. Slide the roll of material onto the
roll holder. Pull the end of the
material away from the
then under and over the tension
arm roller back toward the
7. Seat the three-hole pattern in the
vinyl over the three closely spaced
teeth in each sprocket. Lower the
bail arm and push the bail arm
latch toward the rear of the
so that the latch locks the bail arm
down.
9. Slew the vinyl back and forth so that the squeegees clean the area to be
printed. Leave a leader of at least 2" (5 cm) beyond the left squeegee.
To load the color cartridge
1. Press ONLINE on the keypad. The
display shows the color foil to load.
Note: Your EDGE may include an
alternate GerberColor foil cartridge.
You may use this sample foil instead of
black foil.
2. Clean the printhead with the pen
printhead cleaner or use a pad
moistened with 98% or higher
isopropyl alcohol. Do not soak the
pad with alcohol or you may
damage the printhead. Gently rub
the entire length and width of the
printhead and the surrounding
metal. Dry with a clean, lint-free
pad.
as shown in the illustration.
,
EDGE
EDGE
EDGE
Foil: Black
.