Installing Reflector; Cleaning Reflector - ETC Source Four Zoom Assembly Manual

3: Using the yoke as your handle, raise the housing assembly off of the work surface a few inches
and then firmly tap the housing on the work surface. This should force the reflector out of its
clips.
4: Carefully lift the housing to see if the reflector is released. If it is not, repeat step 3 with slightly
more force.

Installing reflector

Note:
1: Place the reflector housing casting (1) on a flat work surface with the large opening facing up.
2: Install the reflector support spring (5) in the circular opening at the base of the casting.
3: Insert the reflector (6) at an angle, under any three adjacent legs of the reflector's clips.
4: Gently press down on the opposite side of the reflector until it snaps into place under the
remaining clips
.
Note:

Cleaning reflector

WARNING:
Remove dust with a blast of oil-free air or wipe with a clean, lint-free cloth. Isopropyl alcohol, distilled
water or a 50%-50% mixture of each can be used to clean the glass surface.
10
The following assumes all four reflector retainer clips (2) have already been riveted to
the reflector housing casting (1) and the gate bushings (3) installed on the retainer
clips. See Figure 9.
If the reflector does not snap in, turn the casting over. Gently pull on the side of the
reflector that has not snapped in until the rest of the reflector slides into place.
Step 3
Do not use ammonia-based or other harsh commercial cleaners. Clean
reflector only as directed.
Commercially available glass cleaning agents should be avoided as they may
contain ammonia, other harsh chemical detergents or abrasive agents. These
cleaners may damage the glass surface and the Anti-Reflective coatings. Do
not immerse or soak the glass in any cleaning solution.
Under three
adjacent clips
Step 4
Source Four Zoom Assembly Guide