ETC Source Four Zoom Assembly Manual page 12

Hide thumbs Also See for Source Four Zoom:

Table of Contents

Note:

24:

Using the four screws (24), attach the handle (23) to the lamp socket assembly. See

25:

Place the compression spring (8) on the protrusion on the inside of the index hub (6).

26:

Insert bolt (17) through spring (8) and through the index hub (6) of the housing socket (1), joining

the two castings. Make sure wires are not pinched between the two pieces.

27:

Before proceeding, check again to make sure the wires are still positioned as indicated in

. . Adjust if necessary.

28:

Press the two castings together firmly so the bottom of the light baffle (2) sits on top of the cable

clamp (15), then install the X-Y lampset (3) and Z lamp knob (4). Hand tighten the knob all the

way to the right.

CAUTION:

To ensure that the clamp holds the cable tightly, flatten the cable, then fold over the

sleeving before you install the top half of the clamp. Make sure the top edge of the

cable clamp is even with the edge of the socket to prevent interference with lamp

focus movement. Make sure sleeving is not pinched.

You must install Z knob as described above to ensure proper lamp focus

travel.

Figure 3

Figure

Source Four Zoom Assembly Guide

Table of Contents