Hach 1950Plus Instrument Manual page 181

Canadian Interference-causing Equipment Regulation, IECS-003, Class A
FCC PART 15, Class "A" Limits
4195M0040Certification.fm
Standards include:
EN 61000-3-2 Harmonic Disturbances Caused by Electrical Equipment
EN 61000-3-3 Voltage Fluctuation (Flicker) Disturbances Caused by
Electrical Equipment
Additional Emissions Standard/s include:
EN 55011 (CISPR 11), Class "A" emission limits
Supporting test records by Hewlett Packard, Fort Collins, Colorado Hardware
Test Center (A2LA # 0905-01) and certified compliance by Hach Company.
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
Supporting test records by Hewlett Packard, Fort Collins, Colorado Hardware
Test Center (A2LA # 0905-01) and certified compliance by Hach Company.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user
will be required to correct the interference at his own expense. The following
techniques of reducing the interference problems are applied easily.
1. Disconnect the Analyzer from its power source to verify that it is or is not
the source of the interference.
2. If the Analyzer is connected into the same outlet as the device with which
it is interfering, try another outlet.
3. Move the Analyzer away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.
Certification
Page 181
Certification