Mapping - Hach 1950Plus Instrument Manual

5.2.5.3 Set Month
5.2.5.4 Set Year
5.2.5.5 Date Format

5.2.6 Mapping

UVTOCSetup and System Configuration.fm
1. Press ENTER. The Set month screen is displayed.
Setting the day of the month will automatically set the day of the week for
use in the daily validate/calibrate and daily clean functions.
S et m o nt h
10
2. Asterisks will flash on either side of the displayed month. Use the UP or
DOWN buttons to select the correct month.
3. When finished, press ENTER. The selected month is retained in memory
and the Set year screen is displayed .
S et y e ar
1999
Enter the correct year the same way the month was entered.
When finished, press ENTER.
This allows setting the date format to either USA format (mm/dd/yy) or
international format (dd/mm/yy) for display and CSV output.
1. Enter the Date format screen by pressing the UP button while in the Set
year screen.
D at e f or ma t
USA
2. Select between USA and international date formats by pressing ENTER.
3. When the appropriate format is displayed, press ENTER.
Both analog outputs and the five relays (S1 through S5) can be mapped to
output several different entities.
1. Enter the Mapping screen from the Timing screen by pressing the
UP button.
M ap pi n g
2. Press ENTER. The Map analogs screen is displayed.
Section 5
Page 75
Setup Menu