Adjusting The Thread Releaser; Thread Releaser Block; Thread Releaser Connection Plate; Thread Releaser Lever - KANSAI SPECIAL RX/UTC Series Instruction

【6】ADJUSTING THE THREAD RELEASER

6 6 6 6 - - - - 1 Thread releaser block

1 Thread releaser block
1 Thread releaser block 1 Thread releaser block
With the thread trimmer air cylinder rod at the left
end (the air cylinder is not operating), set the
clearance between thread trimmer air cylinder
bracket A and thread releaser block B at 13mm.
Then tighten screw C.

6 6 6 6 - - - - 2 Thread releaser connection plate

2 Thread releaser connection plate 2 Thread releaser connection plate 2 Thread releaser connection plate
Fit thread releaser connection plate D to guide
screw E. Create a clearance between plate D and
thread releaser connection lever G.
Adjustment is made by loosening screw H.

6 6 6 6 - - - - 3 Thread releaser lever

3 Thread releaser lever 3 Thread releaser lever 3 Thread releaser lever
Position thread releaser lever F so that the thread
tension disk can open as fast as possible.
Then tighten screw H for thread releaser connection
lever G at the rear of the arm.
6