Position Of The Thread Eyelet Of The Looper Thread Take-Up; Position Of The Looper Thread Take-Up; Cleaning The Machine - KANSAI SPECIAL V Series Instructions Manual

10- - - - 4 Position of the thread eyelet of the looper thread take 10 10 10 4 Position of the thread eyelet of the looper thread take 4 Position of the thread eyelet of the looper thread take- - - - up 4 Position of the thread eyelet of the looper thread take
Align the eyes on thread eyelets B and C with mark
(a) on guide plate A. To increase the amount of
looper thread to be supplied, move thread eyelets B
and C to the back.
looper thread to be supplied, move thread eyelets B
and C to the front.
loosening screws D. Set the distance from the top
surface of guide plate A to the bottom surface of
thread guide E at 6~7mm. Adjustment is made by
loosening screw F.
Adjust the thread eyelets of the thread take-up
according to the thread and stitch length to be used.
10 10- - - - 5 Position of the looper thread take 5 Position of the looper thread take- - - - up
10 10 5 Position of the looper thread take 5 Position of the looper thread take
When the point of the left needle has reached the
bottom surface of the looper blade while the looper
is moving from the extreme left end of its travel, the
looper thread should be removed properly from
highest position B on thread take-up A.
Adjustment is made by loosening screw C.
【11】CLEANING THE MACHINE
At the end of each day, remove the presser foot and
the needle plate and then clean the slots of the
needle plate and the area around the feed dogs.
To decrease the amount of
Adjustment is made by
up
up up
14
up up up