Adjusting The Thread Releaser; Thread Releaser Block; Thread Releaser Connection Plate; Thread Releaser Lever - KANSAI SPECIAL WX8803/UTC Instruction Manual

【6】ADJUSTING THE THREAD RELEASER

6 6 6 6 - - - - 1 Thread releaser block

1 Thread releaser block
1 Thread releaser block 1 Thread releaser block
With the thread trimmer air cylinder rod or the
solenoid rod at the left end of its travel (the air
cylinder is not operating), there should be a
clearance of 4.0mm between the thread trimmer air
cylinder bracket D and thread releaser block C.
After this adjustment, tighten screw B.

6 6 6 6 - - - - 2 Thread releaser connection plate

2 Thread releaser connection plate 2 Thread releaser connection plate 2 Thread releaser connection plate
Fit thread releaser connection plate A onto guide
screw E with a clearance between A and thread
releaser connection lever G.
Adjustment is made by loosening screw H.

6 6 6 6 - - - - 3 Thread releaser lever

3 Thread releaser lever
3 Thread releaser lever 3 Thread releaser lever
When thread releaser block C operates, thread
tension disk K should open as fast as possible.
To make this adjustment, position thread releaser
lever F and then tighten screw H on thread releaser
connection lever G at the rear end of the arm.
6