Adjusting The Thread Releaser Shaft; Adjusting The Feed Roller; Feed Roller Pressure - KANSAI SPECIAL SX Series Instruction

9 9 9 9 - - - - 4 Adjusting the thread releaser shaft

4 Adjusting the thread releaser shaft
4 Adjusting the thread releaser shaft 4 Adjusting the thread releaser shaft
When the presser foot lift pedal is not pressed, the
upper part of thread releaser pin I should be
positioned between the top and bottom thread
tension disks.
screw J of the presser foot lift lever (Large) and turn
thread releaser shaft K as required with a
screwdriver.
【10】ADJUSTING THE FEED ROLLER
1 1 1 1 0 0 0 0 - - - - 1 1 1 1 Adjusting the movement amount of the feed roller Adjusting the movement amount of the feed roller
Adjusting the movement amount of the feed roller Adjusting the movement amount of the feed roller
Loosen screw C.
Move feed roller lever rod D up or down as required.
To increase the movement amount, move rod D
upward. To decrease the movement amount, move
rod D downward.

1 1 1 1 0 0 0 0 - - - - 2 2 2 2 Feed roller pressure

Feed roller pressure
Feed roller pressure Feed roller pressure
The pressure should be sufficient to feed the fabric
uniformly.
adjusting screw E clockwise.
pressure, turn adjusting screw E counterclockwise.
To make this adjustment, loosen
To increase the
To decrease the
pressure, turn
16