Table of Contents
Advertisement
9 9 9 9 - - - - 2 Disassembling and reassembling the presser foot
2 Disassembling and reassembling the presser foot
2 Disassembling and reassembling the presser foot
2 Disassembling and reassembling the presser foot
■To disassemble the presser foot
Move the presser bar all the way to the up position by
pressing the presser foot lift pedal.
Loosen screw A.
■To reassemble the presser foot
Move the presser bar all the way to the up position by
pressing the presser foot lift pedal.
Install the presser foot with screw A.
Make sure the presser foot is replaced onto the flat spot
of the presser bar. The needles should drop into the
centers of the needle drop holes on the presser foot.
To make this adjustment, loosen screw B of the presser
bar clamp and turn the presser bar.
■To adjust the presser bar clamp
Loosen screw B of the presser bar clamp with the
presser foot tightly rested on the top surface of the
needle plate. Clearance between presser foot link C
and screw D should be approximately 0.5mm.
9 9 9 9 - - - - 3 Presser foot lift
3 Presser foot lift
3 Presser foot lift
3 Presser foot lift
With the presser foot tightly rested on the top surface
of the needle plate (the presser foot lift pedal is not
pressed), there should be a clearance of approximately
0.5mm between presser foot link C and screw D of the
presser bar clamp. To make this adjustment, adjust
screw J on the presser foot lift lever or screws L.
9 9 9 9 - - - - 4 Adjusting the thread releaser shaft
4 Adjusting the thread releaser shaft
4 Adjusting the thread releaser shaft
4 Adjusting the thread releaser shaft
When the presser foot lift pedal is not pressed, the
upper part of thread releaser pin I should be positioned
between the top and bottom thread tension disks.
To make this adjustment, loosen screw J of the presser
foot lift lever (Large) and turn thread releaser shaft K
as required with a screwdriver.
15
Hide quick links:
Advertisement
Table of Contents
