Thread Releaser Plate; Thread Releaser Hook; Safety Detector - KANSAI SPECIAL RX/UTC Series Instruction

6 6 6 6 - - - - 4 Thread releaser plate

4 Thread releaser plate 4 Thread releaser plate 4 Thread releaser plate
Install thread releaser bar D to thread releaser bar
connection plate F with screw G.
The top end of thread releaser bar D should
protrude 39mm from the top surface of thread
releaser bar guide E. There should be a clearance
of 4mm between washer H and thread releaser bar
guide E.

6 6 6 6 - - - - 5 Thread releaser hook

5 Thread releaser hook 5 Thread releaser hook 5 Thread releaser hook
The needle thread should not protrude long from the
underside of the fabric at the start of sewing.
Loosen screw I and adjust thread releaser hook J.
To decrease the amount of the thread supplied by
the thread take-up, raise the thread releaser hook.
To increase the amount, lower the thread releaser
hook. If the amount is too little, the stitches cannot
be formed at the start of sewing.
【7】SAFETY DETECTOR
■ T he safety detector is included so that the machine
will not start until the thread trimmer cuts the
threads and returns home safely.
Switch A of the detector must be pressed (ON)
during sewing (with the thread trimmer completely
returned home). Adjust by loosening screws B and
E and moving brackets C and D.
7