Adjusting The Thread Releaser Shaft; Adjusting The Feed Roller; Adjusting The Movement Amount Of The Feed Roller; Feed Roller Pressure - KANSAI SPECIAL SX Series Instructions Manual

9-4 Adjusting the thread releaser shaft

When the presser foot lift pedal is not pressed, the
upper part of thread releaser pin I should be
positioned between the top and bottom thread
tension disks.
screw J of the presser foot lift lever (Large) and turn
thread releaser shaft K as required with a
screwdriver.
【10】ADJUSTING THE FEED ROLLER

10-1 Adjusting the movement amount of the feed roller

Loosen screw C.
Move feed roller lever rod D up or down as required.
To increase the movement amount, move rod D
upward. To decrease the movement amount, move
rod D downward.

10-2 Feed roller pressure

The pressure should be sufficient to feed the fabric
uniformly. To increase the pressure, turn adjusting
screw E clockwise.
To decrease the pressure, turn adjusting screw E
counterclockwise.
To make this adjustment, loosen
18