Adjusting The Thread Releaser; Thread Releaser Lever; Thread Releaser Plate; Thread Releaser Hook - KANSAI SPECIAL DX Series Instruction Manual

【5】ADJUSTING THE THREAD RELEASER

5 5 5 5 - - - - 1 Thread releaser lever

1 Thread releaser lever
1 Thread releaser lever 1 Thread releaser lever
When thread releaser cylinder H gets activated, the
thread tension disks should open as soon as possible.
Adjustment is made by positioning thread releaser
lever I. After the adjustment tighten screw J (located
behind the arm) for the thread releaser lever.

5 5 5 5 - - - - 2 Thread releaser plate

2 Thread releaser plate 2 Thread releaser plate 2 Thread releaser plate
Adjust the position of thread releaser plate G so that
the tension disks will open as soon as possible.
To make this adjustment, install thread releaser bar A
to thread releaser bar connection plate F with screw E.
The top end of thread releaser bar A should protrude
50mm from the top surface of thread releaser bar guide
B. There should be a clearance of 4mm between E
ring K and thread releaser bar guide B.

5 5 5 5 - - - - 3 Thread releaser hook

3 Thread releaser hook 3 Thread releaser hook 3 Thread releaser hook
The needle threads should not protrude long from the
back side of the fabric at the start of sewing.
Loosen screw C and adjust the position of thread
releaser hook D.
threads to be supplied, raise the thread releaser hook.
To increase the amount of the threads to be supplied, lower the thread releaser hook.
Note that the stitches are not formed at the start of sewing if the amount is too little.
【6】SAFETY DETECTOR
■ T he safety detector is included so that the machine will
not start running until the thread trimmer cuts the
threads and returns home safely.
Switch A must be kept pressed (ON) during sewing
(with the thread trimmer completely returned home).
Adjustment is made by loosening screws B and E and
moving brackets C and D.
To decrease the amount of the
5