【1】SPECIFICATIONS
1-1 Stitch type
JIS401 double chainstitch machines
1-2 Model
Model
1502
No. of needles
2
No. of threads
4
No. of loopers
2
UY×128GAS
Needle count
#14~#18
Needle space
3/16,1/4,5/16
Needle bar stroke
【2】NEEDLES & THREADING THE MACHINE
2-1 Needles
UY×128GAS,TV×5 of Schmetz or Organ
Select the proper needle for the fabric and thread.
< Needle count comparison table >
Schmetz
Nm90
Nm95
Nm100 Nm105 Nm110 Nm120 Nm125 Nm130
Organ
# 14
# 15
# 16
2-2 Replacing the needle
When replacing the needle, check the needle carefully to
see that the scarf is turned to the rear of the machine
(see the illustration).
< Note >
When replacing the needle, be sure to turn off the
machine. A clutch motor continues running for a while
after the machine is turned off.
Therefore keep on
pressing the pedal until the machine stops.
1503
1508
1509
3
4
6
6
8
12
3
4
6
TV×5 #21
TV×5 #21
TV×5 #21
1/4,9/32
1 1/2 (最大)
1 1/2 (最大)
34mm
# 17
# 18
# 19
# 20
# 21
DLR
series
1
2-3 To thread the machine
Thread the machine correctly by referring to the next page.
Incorrect threading may cause skip stitching, thread breakage and/or uneven stitch
formation.
When threading the looper, tilt the looper holder toward the front of the
machine by means of the looper drawing bar.
■To tilt the looper toward the front
1.
Bring the needle bar to the top of its stroke.
2.
On 1508 and 1509, tilt looper holder B toward the front of the machine by pressing
pushbutton flat spring A (see below).
3.
On 1502 and 1503, tilt looper holder D to the right by pressing connecting bar C down
(see below).
4.
After the machine is threaded, replace the looper holder.
2
DLR
series