Looper Thread Take-Up; Thread Releaser Plate; Thread Releaser Hook; Safety Detector - KANSAI SPECIAL WX8803/UTC Instruction Manual

6 6 6 6 - - - - 4 Looper thread take 4 Looper thread take- - - - up 4 Looper thread take 4 Looper thread take
This machine is equipped with looper thread
take-up L. Thread looper thread take-up L with a
looper thread.

6 6 6 6 - - - - 5 Thread releaser plate

5 Thread releaser plate
5 Thread releaser plate 5 Thread releaser plate
The thread tension disks should open as fast as
possible. To make this adjustment, loosen screw B
on thread releaser plate adjusting collar A and then
adjust the position of thread releaser plate C.
With the upper end of thread releaser bar D 39mm
protruded from the top surface of thread releaser
bar guide E, secure thread releaser bar D on thread
releaser connection plate F with screw G.
In the above condition, the length of spring H should
be approximately 4mm.

6 6 6 6 - - - - 6 Thread releaser hook

6 Thread releaser hook 6 Thread releaser hook 6 Thread releaser hook
The needle thread should not be shown long on the
back of the fabric. Adjustment is made by
loosening screw I and positioning thread releaser
hook J.
To decrease the amount of thread to be supplied,
raise the thread releaser hook. To increase the
amount of thread to be supplied, lower the thread
releaser hook.
Do not decrease the amount too much. Otherwise stitches at the start of sewing will not
be formed.
【7】SAFETY DETECTOR
■ The safety detector is included so that the machine
will not run if the thread trimmer does not return
home safely after the operation. Switch A on the
safety detector must be ON (switch A is pressed)
during sewing (the thread trimmer is completely at
home). Adjustment is made by loosening screws B
and E and moving brackets C and D as required.
up up up
7