Advertisement
port interface
stg
vlan
interface
number
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
Version 4.2.1.0
History
Usage
Information
Trace Logging Commands
Trace logging is a critical debugging tool most often used by the Dell Force10 Technical Assistance
Center (TAC) to isolate and resolve both software and hardware issues.
•
•
•
•
•
•
The keywords
line card.
The keyword
on a line card.
The keyword
particular line card.
Enter one of the following keywords and slot/port or number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
Enter a number after the following keywords:
•
After the keyword
Range: 0-7 for the C300; 0-3 for the C150
•
After the
•
Range: 1-128
•
After the keyword
•
After the keyword
Range: 1 - 4095 for the C300
Introduction
Warning:
Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
debug cpu-traffic-stats
show command-history
show console lp
show cpu-traffic-stats
show hardware linecard fpga
show hardware rpm fpga
port interface
show Layer 2 information for a port on a particular
stg
shows the state of each port in a particular Spanning Tree Group
vlan
shows Layer 2 information in the MAC Agent for a VLAN on a
linecard
:
port-channel
keyword, enter the port-channel number.
stg
, enter the Spanning Tree Group number.
vlan
:
C-Series Diagnostics and Debugging | 1519
GigabitEthernet
TenGigabitEthernet
Advertisement
