Advertisement
Related
show hardware system-flow layer2 linecard port-set
Commands
show hardware acl
c
View Layer 2 or Layer 3 access control list entries.
Syntax
show hardware {layer2 | layer 3} acl linecard number port-set number
Parameters
layer2
layer3
number
Defaults
None
Command Mode
EXEC
EXEC Privilege
Command
Version 4.2.1.0
History
Usage
Information
show hardware layer3 qos linecard port-set
c
View Layer 3 QoS messages.
Syntax
show hardware layer3 qos linecard port-set
Parameters
number
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
Version 7.5.1.0
History
Introduction
Warning:
Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
Introduction
View system-flow entries.
layer2
Enter the keyword
to view Layer 2 access control list
entries for the specified line card
layer3
Enter the keyword
to view Layer 3 access control list
entries for the Forwarding Processor of the specified line card.
Enter a number after the following keywords:
linecard
•
After the keyword
Range: 0-7 for the C300; 0–3 for the C150
port-set
•
After the keyword
Enter a number after the following keywords:
linecard
•
After the keyword
Range: 0-7 for the C300
port-set
•
After the keyword
C-Series Diagnostics and Debugging | 1515
.
:
, enter the Port-Pipe/FB ID.
:
, enter the Port-Pipe/FB ID.
Advertisement
