Advertisement
Example
ACL and System-Flow Debug Commands
clear hardware system-flow
c
Syntax
Parameters
Defaults
Command Mode
Command
History
Usage
Information
1514
|
C-Series Diagnostics and Debugging
Figure 64-14. show revision Command Example
FTOS#show revision
-- RPM 0 --
C300 RPM FPGA : 3.8
Required FPGA version : 3.8
-- Secondary RPM --
C300 RPM FPGA : 3.8
Required FPGA version : 3.8
-- Line card 3 --
48 Port 1G LCM FPGA : 2.6
Required FPGA version : 2.6
-- Line card 7 --
48 Port 1G LCM FPGA : 2.6
Required FPGA version : 2.6
FTOS#
•
clear hardware system-flow
•
show hardware acl
•
show hardware layer3 qos linecard port-set
•
show hardware system-flow layer2 linecard port-set
Clear system-flow entry counters.
clear hardware system-flow layer2 linecard number port-set number counters
number
None.
EXEC
EXEC Privilege
Version 4.2.1.0
Introduction
Warning:
Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
Enter a number after the following keywords:
linecard
•
After the keyword
Range: 0-7 for the C300
port-set
•
After the keyword
:
, enter the Port-Pipe/FB ID.
Advertisement
