Danfoss VLT Series Design Manual page 116

5. How to Install
MCT 10 Set-up Software
MCT 10 has been designed as an easy-to-use interactive tool for setting parameters in our ad-
justable frequency drives.
The MCT 10 Set-up software will be useful for:
•
•
•
•
•
•
5
MCT 10 Set-up Software support Profibus DP-V1 via a Master class 2 connection. This makes it
possible to access on-line read/write parameters in an adjustable frequency drive via the Profibus
network. This will eliminate the need for an extra communication network.
Save Drive Settings:
1.
2.
3.
4.
All parameters are now stored on the PC.
Load Drive Settings:
1.
2.
3.
4.
5.
All parameter settings are now transferred to the drive.
A separate manual for MCT 10 Set-up software is available.
The MCT 10 Set-up Software Modules
The following modules are included in the software package:
116
Planning a communication network off-line. MCT 10 contains a complete adjustable fre-
quency drive database.
Commissioning adjustable frequency drives on-line.
Saving settings for all adjustable frequency drives.
Replacing a drive in a network
Expanding an existing network.
Drives developed in the future will be fully supported.
Connect a PC to the unit via the USB com port.
Open MCT 10 Set-up software
Choose "Read from drive".
Choose "Save as".
Connect a PC to the unit via the USB com port.
Open MCT 10 Set-up software
Choose "Open"– stored files will be shown.
Open the appropriate file.
Choose "Write to drive."
MG.11.B4.22 - VLT ® is a registered Danfoss trademark.
VLT ® HVAC Drive Design Guide