Danfoss VLT Series Design Manual page 115

VLT ® HVAC Drive Design Guide
5.5.2. How to Connect a PC to the FC 100
To control or program the adjustable frequency drive from a PC, install the MCT 10 Set-up soft-
ware.
The PC is connected via a standard (host/device) USB cable, or via the RS-485 interface as shown
in the
tions
.
PC Software - MCT 10
All drives are equipped with a serial communication port. We provide a PC tool for communication
between PC and adjustable frequency drive, called the VLT Motion Control Tool MCT 10 Set-up
software.
NOTE
Communication protocol must be set to FC MC par. 8-30.
VLT ® HVAC Drive Design Guide, chapter How to Install > Installation of misc. connec-
NOTE
The USB connection is galvanically isolated from the supply voltage (PELV) and other
high-voltage terminals. The USB connection is connected to protection ground on
the adjustable frequency drive. Only use an isolated laptop as the PC connection to
the USB connector on the VLT HVAC Drive.
MG.11.B4.22 - VLT ® is a registered Danfoss trademark.
5. How to Install
5
115