Wiring The Redundant Power Inputs; Communication Connections; 10/100Baset(X) Ethernet Port Connection - Moxa Technologies AWK-1127 Quick Installation Manual

Arrester Accessories
SA-NMNF-01: Surge arrester, N-type (male) to N-type (female)
•
• SA-NFNF-01: Surge arrester, N-type (female) to N-type (female)

Wiring the Redundant Power Inputs

The 4-contact terminal block connector on the AWK-1127's top panel is
used for the AWK-1127's two DC inputs. The top and front views of the
terminal block connector are shown here.
Top View
Front View
ATTENTION
Before connecting the AWK-1127 to the DC power inputs, make
sure the DC power source voltage is stable.

Communication Connections

10/100BaseT(X) Ethernet Port Connection

The 10/100BaseT(X) ports located on the AWK-1127's front panel are
used to connect to Ethernet-enabled devices.
Below we show pinouts for both MDI (NIC-type) ports and MDI-X
(HUB/Switch-type) ports.
STEP 1: Insert the negative/positive DC wires
into the V-/V+ terminals.
STEP 2: To keep the DC wires from pulling loose,
use a small flat-blade screwdriver to tighten the
wire-clamp screws on the front of the terminal
block connector.
STEP 3: Insert the plastic terminal block
connector prongs into the terminal block
receptor, which is located on the AWK-1127's top
panel.
- 8 -