Kelvion KBloc Operating Instructions Manual page 81

6.
Tighten all nuts to suit the respective gasket type.
Tighten to the specified torque, see „7.4.2.1 Tightening the panel – to

the specified torque on panels with corner bolt hole" (page 82).
Tighten to the specified torque, see „7.4.2.2 Tightening the panel – to

the specified torque on panels without corner bolt hole" (page 86).
Tighten to the specified gap size, see „7.4.2.3 Tightening the panel - to

a gap dimension" (page 90).
Panel with
corner bolt hole

Done.
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016
Panel without
corner bolt hole
Chapter 7
Maintenance
81