Kelvion KBloc Operating Instructions Manual page 45

5.4.2.3 VERTICAL-TYPE K°BLOC - DELIVERED IN HORIZONTAL POSITION
The vertical-type K°Bloc can be either transported with a fork lift truck when
fastened to the transport pallet or fastened and transported with round slings
and shackles. The section below describes how to properly fasten and trans-
port the unit using round slings and shackles as an example.
Requirement:

The K°Bloc is still packaged.
Tools required:

Lifting equipment with sufficient load-carrying capacity

Load holding devices (round slings with shackles or suitable cross-
beam) with sufficient load-carrying capacity
Fastening a vertical-type K°Bloc delivered in horizontal position properly
WARNING
Danger of injury by heavy weight of K°Bloc!
The K°Bloc may slip off and fall down during transport when incorrectly
fastened. You may suffer serious injuries and bruises in such an accident.
 Never stand underneath suspended loads!
 Always use approved load holding devices with sufficient load-carrying
capacity!
 Always use approved lifting equipment with sufficient load-carrying capa-
city!
 Wear safety shoes at all times!
 Lift and lower the K°Bloc evenly and slowly.
 Never lift or lower the K°Bloc diagonally to the direction of the transporta-
tion lifting lug.
 Never transport the K°Bloc at the threaded bolts!
 Fasten the load holding devices only at the marked fastening points for
transporting the K°Bloc!
 Never attach the lifting slings to the connections!
 Avoid any pendulum movements of the K°Bloc!
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016
Setting up and connecting the K°Bloc
Chapter 5
45