Table of Contents
Advertisement
Setting up a horizontal-type K°Bloc delivered in horizontal position | special-design
K°Bloc at the place of installation
Carry out the following steps:
1.
Remove the transport packaging, see section „5.3 Removing and
disposing of transport packaging" (page 30).
2.
Carefully lift the K°Bloc.
!
Make sure that you lift the K°Bloc only as high as necessary.
3.
Put down the K°Bloc carefully at its intended position.
4.
Anchor the K°Bloc to the foundation, using suitably dimensioned bolts
and nuts.
5.
Remove the four shackles and round slings from the support angles.
The horizontal-type K°Bloc delivered in horizontal position | special-design
K°Bloc has now been set up at the place of installation.
Done.
44
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016
Advertisement
Table of Contents
