Kelvion KBloc Operating Instructions Manual page 80

3.
Approach the panel carefully to the K°Bloc over the threaded bolts.
!
Ensure that the threads of threaded bolts and the gasket will not be da-
maged when positioning the panel.
!
Ensure that all end plate collars and columns engage in the panel reces-
ses and that the gasket has not slipped.
4.
Fit all nuts with the associated washers.
!
Tighten the nuts only hand-tight.
5.
Remove the lifting equipment attached to the panel.
80
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016