Removing And Disposing Of Transport Packaging - Kelvion KBloc Operating Instructions Manual

TIP
If necessary, dismount inlet/outlet lines to provide enough space for
manoeuvring at the place of installation.
5.3 REMOVING AND DISPOSING OF
TRANSPORT PACKAGING
Transport the packaged K°Bloc in its transport packaging as long as
possible. This is to prevent damage to the K°Bloc on its way to the place of
installation. Remove the transport packaging only at the place of installation
if possible.
Carry out the following steps:
1.
Remove the transport packaging.
!
Leave the transport plugs on the piping connections if you do not fit the
piping immediately. Leave the K°Bloc bolted down to the transport sup-
port until it has been transported to its final place of installation.
2.
In case of seaworthy packaged K°Bloc units, remove the desiccant
packs including those in the connections without damaging them.
3.
Dispose of the transport packaging in accordance with applicable regula-
tions.

Done.
30
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016