Kelvion KBloc Operating Instructions Manual page 54

IMPORTANT NOTE
Damage to piping connections and to K°Bloc due to exces-
sive forces and torques!
When excessive forces and torques are transmitted on the K°Bloc connec-
tions through the piping, the piping connections and/or the K°Bloc may be
damaged.
 You can take the forces and torques permitted for your K°Bloc from the
technical documentation.
 Ensure that the forces and torques transmitted from the piping to the
K°Bloc connections are not too high.
Carry out the following steps:
1.
Check on the K°Bloc if all safety accessories required for the flow
medium used are fitted, see chapter „5.5.1 Optional safety accessories"
(page 51).
2.
Open the valve on K°Bloc units filled with compressed air or inert gases.
3.
Lay all necessary pipes.
4.
Connect the inlet and outlet pipes to the connections of the K°Bloc.
5.
Check if all pipes and connections are tight.

Done.
54
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016