Kelvion KBloc Operating Instructions Manual page 37

5.4.2.1 HORIZONTAL-TYPE K°BLOC | STANDARD K°BLOC
The horizontal-type K°Bloc can be fastened and transported either with a
cross-beam or with round slings and shackles. The section below describes
how to properly fasten and transport the unit using round slings and
shackles.
Requirement:

The K°Bloc is still packaged.
Tools required:

Lifting equipment with sufficient load-carrying capacity

Load holding devices (round slings with shackles or suitable cross-
beam) with sufficient load-carrying capacity
Fastening a horizontal-type K°Bloc delivered in horizontal position | standard K°Bloc
properly
WARNING
Danger of injury by heavy weight of K°Bloc!
The K°Bloc may slip off and fall down during transport when incorrectly
fastened. You may suffer serious injuries and bruises in such an accident.
 Never stand underneath suspended loads!
 Always use approved load holding devices with sufficient load-carrying
capacity!
 Always use approved lifting equipment with sufficient load-carrying capa-
city!
 Wear safety shoes at all times!
 Lift and lower the K°Bloc evenly and slowly. Transport the unit horizon-
tally at all times!
 Never transport the K°Bloc at the threaded bolts!
 Fasten the load holding devices only at the marked fastening points for
transporting the K°Bloc!
 Never attach the lifting slings to the connections!
 Avoid any pendulum movements of the K°Bloc!
Carry out the following steps:
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016
Setting up and connecting the K°Bloc
Chapter 5
37