Kelvion KBloc Operating Instructions Manual page 59

Carry out the following steps:
1.
Check on the K°Bloc if all safety accessories required for the flow
medium used are fitted, see chapter „5.5.1 Optional safety accessories"
(page 51).
2.
Check if all nuts have been tightened to the torques or tightening dimen-
sions specified in the technical documentation and correct if necessary.
3.
Vent the K°Bloc completely.
4.
Always open or close the valves of the piping connected to the K°Bloc
slowly.
5.
Avoid sudden condensation of gases by suitable process control.
6.
Check if all pipes and connections are tight.

Done.
K°Bloc – Fully welded plate heat exchangers - English Version 2.2 - 01.2016
Commissioning and decommissioning, operation
Chapter 6
59