Install The Tank Hose - Raven RS1 Installation Manual

FIGURE 6. Pressure Hose Installed
3. Install a -6 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-069) on the steel pressure line.
4. Connect the machine's pressure hose to the opposite end of the installed tee fitting.
5. Install the 90° end of the supplied hydraulic hose (P/N 214-1000-657) on the 90° end of the installed tee fitting.
6. Connect the straight end of the installed hydraulic hose to Port P of the steering valve.

INSTALL THE TANK HOSE

1. Locate the machine's steel tank line.
NOTE: The pressure line runs on the inside of the frame from the rear of the machine. Trace it to the T port
on the steering orbital if necessary.
2. Disconnect the machine's tank hose from the steel tank line.
FIGURE 7. Tank Hose Installed
Machine's Tank Hose
-8 ORFS M/M/F
Swivel Run Tee Fitting
(P/N 333-0012-028)
3. Install a -8 ORFS M/M/F swivel run tee adapter fitting (P/N 333-0012-028) on the machine's steel tank line.
4. Connect the machine's tank hose to the opposite end of the installed tee fitting.
5. Install the -8 end of the supplied hydraulic hose (P/N 214-1000-658) on the 90° end of the installed tee fitting.
6. Connect the other end of the installed hydraulic hose to Port T of the steering valve.
P/N 016-5032-104 Rev. B
HYDRAULIC SYSTEM INSTALLATION
Installed Hydraulic
Hose
(P/N 214-1000-658)
Steel Tank Line
17