Raven RS1 Installation Manual page 35

4. Locate the machine's X-200 POWER GND PORT INTERFACE connection on the machine's harness, stored in the
vent compartment.
5. Connect the POWER connector of the RS1 HDU harness cable to the machine's X-200 POWER GND PORT
INTERFACE connector.
FIGURE 10. 12-Pin RS1 Harness Connector Routing
6. Route the black 12-pin connector of the RS1 HDU harness out the back of the instructional seat, along the vent
compartment, and through the hole in the floor of the cab.
7. Route the black 12-pin connector up the back of the cab and along the roof.
FIGURE 11. RS1 Connection
8. Connect the black 12-pin connector to the back of the RS1 unit.
9. Route the round 7-pin connector of the RS1 HDU harness out the back of the instructional seat, through the
vent compartment, and along the cab door.
P/N 016-5032-104 Rev. B
CAB COMPONENT INSTALLATION
31