Raven RS1 Installation Manual page 27

FIGURE 4. Rod-End of WAS Installed on Rod-End of Steering Cylinder
Rod-End of
WAS
12. Install the ball mount on the rod-end of the WAS assembly on the installed hex bolt and secure it using an M10
x 1.5 lock nut (P/N 312-4000-208).
FIGURE 5. Base-End of WAS Installed on Base-End of Steering Cylinder
13. Insert an M10 x 1.5 x 35 hex bolt (P/N 311-0070-025) through the back of the WAS base end mounting bracket.
14. Install the base-end of the WAS assembly on the hex bolt and secure it using an M10 x 1.5 nylon insert lock nut
(P/N 312-4000-208).
15. Orient the WAS so the cable plug is oriented as shown in Figure 5 on page 23.
P/N 016-5032-104 Rev. B
WHEEL ANGLE SENSOR INSTALLATION
M10 x 1.5 Lock Nut
(P/N 312-4000-208)
M10 Universal Ball Mount
(P/N 103-0001-029)
23