Lubrication; Decal Placement - Landoll 876 Series Operator's Manual

3-11 LUBRICATION

The 876 Wing Series Tilloll must be lubricated
before using it for the first time, and at regular in-
tervals thereafter. Use a standard multi-purpose
grease (See Section 4-13) to lubricate your 876
Wing Series Tilloll.

3-12 DECAL PLACEMENT

Decals are extremely important for naming pur-
poses and for alerting others to the presence of
the machine. PLACE ALL DECALS on the 876
Wing Series Tilloll as shown in Figure 3-12. Cen-
ter them as nearly as possible between the top
and bottom on the frame bar. Sometimes, shank
spacing may position a tool frame too near the end
of the frame bar to place a reflective tape square
exactly as shown. Then place the square between
the u-bolts on the tool frame as near the proper lo-
cation as possible. A red reflective square is at-
tached to the rear of the left- and right-hand end
tool frames at the factory. If any decals become
unreadable, or are destroyed during use, get re-
placement decals from your Landoll dealer as soon
as possible, and replace them on the machine.
3-23