Parksense Sensors; Parksense Display - Jeep CHEROKEE 2020 Owner's Manual

Refer to "ParkSense System Usage
Precautions" in this section for limitations of
this system and recommendations.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is placed in the ON position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is enabled
at this gear selector position, the system will
remain active until the vehicle speed is
increased to approximately 7 mph (11 km/h) or
above. When in REVERSE and above the
system's operating speed, a warning will appear
within the instrument cluster display indicating
the vehicle speed is too fast.
The system will become active again if the
vehicle speed is decreased to speeds less than
approximately 6 mph (9 km/h).
P S S
ARK ENSE ENSORS
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the
vehicle that is within the sensors' field of view.
The sensors can detect obstacles from
approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear fascia/
bumper in the horizontal direction, depending
on the location, type and orientation of the
obstacle.
STARTING AND OPERATING
P S D
ARK ENSE ISPLAY
The ParkSense display is always shown in the
instrument cluster display as long as the vehicle
is in REVERSE.
The system will indicate a detected obstacle by
showing a single arc in the left and/or right rear
regions based on the obstacle's distance and
location relative to the vehicle.
233
5