Parksense Rear Park Assist; If Equipped - Jeep CHEROKEE 2020 Owner's Manual

232 STARTING AND OPERATING
To Resume Speed
To resume a previously set speed, push the RES
button and release. Resume can be used at any
speed above 20 mph (32 km/h).
To Turn Off
The system will turn off and erase the set speed
in memory if:
The Normal (Fixed Speed) Cruise Control on/

off button is pushed.
The ignition is placed in the OFF position.

Four-Wheel Drive Low is engaged

The Adaptive Cruise Control (ACC) on/off

button is pushed
PARKSENSE REAR PARK ASSIST — IF
EQUIPPED
The ParkSense Rear Park Assist system
provides visual and audible indications of the
distance between the rear fascia and a
detected obstacle when backing up (e.g. during
a parking maneuver).
If your vehicle is equipped with an automatic
transmission, the vehicle brakes may be
automatically applied and released when
performing a reverse parking maneuver if the
system detects a possible collision with an
obstacle. Refer to "Uconnect Settings" in
"Multimedia" for information on turning Rear
Braking Assist on or off.
NOTE:
The driver can disable the automatic braking

function by turning ParkSense off via the
ParkSense switch. The driver can also over-
ride automatic braking by changing the gear
or by pressing the gas pedal over 90% of its
capacity during the braking event.
Automatic brakes are not available if the

vehicle is in 4WD Low.
Automatic brakes will not be available if there

is a faulted condition detected with the Park-
Sense Park Assist system or the Braking
System Module.
The automatic braking function may only be

applied if the vehicle deceleration is not
enough to avoid colliding with a detected
obstacle.
The automatic braking function may not be

applied fast enough for obstacles that move
toward the rear of the vehicle from the left
and/or right sides.
The automatic braking function can be

enabled/disabled from the
Customer-Programmable Features section of
the Uconnect system.
ParkSense will retain its last known configu-

ration state for the automatic braking func-
tion through ignition cycles.
The automatic braking function is intended to
assist the driver in avoiding possible collisions
with detected obstacles while in REVERSE gear.
NOTE:
The driver is always responsible for

controlling the vehicle.
The system is provided to assist the driver

and not to substitute the driver.
The driver must stay in full control of the

vehicle's acceleration and braking and is
responsible for the vehicle's movements.