Overtake Aid; Acc Operation At Stop - Jeep CHEROKEE 2020 Owner's Manual

224 STARTING AND OPERATING
If there is no vehicle ahead, the vehicle will
maintain the set speed. If a slower moving
vehicle is detected in the same lane, the
instrument cluster display will show the ACC Set
With Target Light icon, and the system will
adjust the vehicle speed automatically to
maintain the distance setting, regardless of the
set speed.
The vehicle will then maintain the set distance
until:
The vehicle ahead accelerates to a speed

above the set speed.
The vehicle ahead moves out of your lane or

view of the sensor.
The distance setting is changed.

The system disengages. (Refer to the infor-

mation on ACC Activation).
The maximum braking applied by ACC is limited;
however, the driver can always apply the brakes
manually, if necessary.
NOTE:
The brake lights will illuminate whenever the
ACC system applies the brakes.
A Proximity Warning will alert the driver if ACC
predicts that its maximum braking level is not
sufficient to maintain the set distance. If this
occurs, a visual alert "BRAKE" will flash in the
instrument cluster display and a chime will
sound while ACC continues to apply its
maximum braking capacity.
Brake Alert
NOTE:
The "BRAKE!" Screen in the instrument cluster
display is a warning for the driver to take action
and does not necessarily mean that the
Forward Collision Warning system is applying
the brakes autonomously.
O A
VERTAKE ID
When driving with Adaptive Cruise Control (ACC)
engaged and following a vehicle, the system will
provide an additional acceleration up to the ACC
set speed to assist in passing the vehicle. This
additional acceleration is triggered when the
driver utilizes the left turn signal and will only be
active when passing on the left hand side.
ACC O A S
PERATION T TOP
If the ACC system brings your vehicle to a
standstill while following a target vehicle, your
vehicle will resume motion, without the need for
any driver action, if the target vehicle starts
moving within two seconds of your vehicle
coming to a standstill.
If the target vehicle does not start moving within
two seconds of your vehicle coming to a
standstill, the driver will either have to push the
RES button, or press the accelerator to
reengage the ACC to the existing set speed.