Jeep CHEROKEE 2020 Owner's Manual page 17

Push and release the unlock button on the key
fob once to unlock the driver's door or twice
within five seconds to unlock all doors and the
liftgate.
All doors can be programmed to unlock on the
first push of the unlock button. Refer to
"Uconnect Settings" in "Multimedia" for further
information.
NOTE:
If the vehicle is unlocked using the interior door
panel, and no door is opened within
60 seconds, the vehicle will re-lock and if
equipped, the security alarm will arm. To
change the current setting, refer to "Uconnect
Settings" in "Multimedia" for further informa-
tion.
The turn signal lights will flash to acknowledge
the unlock signal. The illuminated entry system
will be activated.
1st Push Of Key Fob Unlock Button
This feature lets you program the system to
unlock either the driver's door or all doors on
the first push of the unlock button on the key
fob. To change the current setting, refer to
"Uconnect Settings" in "Multimedia" for further
information.
NOTE:
If the vehicle is equipped with Passive Entry,
refer to "Keyless Enter-N-Go — Passive Entry"
located in "Doors" in "Getting To Know Your
Vehicle" for further information.
To Lock The Doors And Liftgate
Push and release the lock button on the key fob
to lock all doors and liftgate.
The turn signal lights will flash and the horn will
chirp to acknowledge the signal. Refer to
"Uconnect Settings" located in "Multimedia" for
further programmable information.
If the vehicle is equipped with Passive Entry,
refer to "Keyless Enter-N-Go — Passive Entry"
located in "Doors" in "Getting To Know Your
Vehicle" for further information.
GETTING TO KNOW YOUR VEHICLE
Vehicles Equipped With Keyless Enter-N-Go —
Passive Entry
If one or more doors are open, or the liftgate is
open, the doors will lock. The doors will unlock
again automatically if the key is left inside the
passenger compartment, otherwise the doors
will stay locked.
Replacing The Battery In The Key Fob With
Remote Control
The replacement battery is one CR2032
battery.
NOTE:
Perchlorate Material — special handling may

apply. See www.dtsc.ca.gov/hazard-
ouswaste/perchlorate for further informa-
tion.
Do not touch the battery terminals that are

on the back housing or the printed circuit
board.
15
2