Jeep CHEROKEE 2020 Owner's Manual page 241

NOTE:
The driver can disable the automatic braking

function by turning ParkSense off via the
ParkSense switch. The driver can also over-
ride automatic braking by changing the gear
or by pressing the gas pedal over 90% of its
capacity during the braking event.
Automatic brakes are not available if the

vehicle is in 4WD Low.
Automatic brakes will not be available if there

is a faulted condition detected with the Park-
Sense Park Assist system or the Braking
System Module.
The automatic braking function may only be

applied if the vehicle deceleration is not
enough to avoid colliding with a detected
obstacle.
The automatic braking function may not be

applied fast enough for obstacles that move
toward the rear of the vehicle from the left
and/or right sides.
The automatic braking function can be

enabled/disabled from the Customer
Programmable Features section of the Ucon-
nect system.
ParkSense will retain its last known configu-

ration state for the automatic braking func-
tion through ignition cycles.
The automatic braking function is intended to
assist the driver in avoiding possible collisions
with detected obstacles when backing up in
REVERSE gear.
STARTING AND OPERATING
NOTE:
The driver is always responsible for

controlling the vehicle.
The system is provided to assist the driver

and not to substitute the driver.
The driver must stay in full control of the

vehicle's acceleration and braking and is
responsible for the vehicle's movements.
Refer to "ParkSense System Usage
Precautions" for limitations of this system and
recommendations.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is placed in the ON position.
239
5