Table of Contents
Advertisement
1. Remove the mini-latch plate and regular
latch plate from its stowed position in the
left rear side trim panel.
Mini-Latch Stowage
2. Grasp the mini-latch plate and pull the seat
belt over the seat.
Shoulder Belt Routed Through The Seat Belt
Guide Loop
3. Route the shoulder belt through the seat
belt guide loop on the top of the seatback
near the inboard side of the left head
restraint.
Inserting Mini-Latch Plate Into Mini-Buckle
4. When the seat belt is long enough to fit,
insert the mini-latch plate into the
mini-buckle until you hear a "click."
Mini-Latch Plate Buckled
5. Sit back in seat. Slide the regular latch plate
up the webbing as far as necessary to allow
the seat belt to go around your lap.
6. When the seat belt is long enough to fit,
insert the latch plate into the buckle until
you hear a "click."
7. Position the lap belt so that it is snug and
lies low across your hips, below your
abdomen. To remove slack in the lap belt
portion, pull up on the shoulder belt. To
loosen the lap belt if it is too tight, pull on
the lap belt. A snug seat belt reduces the
risk of sliding under the seat belt in a
collision.
SAFETY
155
4
Hide quick links:
Advertisement
Table of Contents
