Inserting Devices Into The To-220 And To-247 Test Fixtures - Keysight Technologies PD1000A Operating Manual

Inserting Devices into the TO-220 and TO-247 Test Fixtures

Figure 7 below shows the proper orientation for inserting TO- style devices into
the Test Fixtures. Always observe proper orientation when inserting devices. The
sockets on the test fixture are spring-loaded to ensure proper contact with the
device leads. Press the device all the way into the fixture sockets.
Figure 7
Removing the Device from the Fixture
To remove the device form the fixture, hold the fixture securely down on a table
or workbench. Carefully and slowly lift the device straight up from the fixture. Do
not rock the device back and forth to remove it.
16
Inserting TO- Style Devices into the TO-220/TO-247 Test Fixtures
PD1000A TO-220 and TO-247 Device Test Fixtures
Gate
Source or
Emitter
Keysight PD1000A Test Fixture Operating Guide
Drain or
Collector